(800) 853-2651
SHOP NOW

Lift All Rebuild

S

sflem849

Well-known Member
I pulled the belly pump from my MD for the clutch split and I go to thinking about giving the Lift All some help.
It doesn't have a whole lot of lift in it anymore. It won't lift my 13' JD disc all the way up w/o putting the tractor in reverse. I am also sure it has a couple leaks, but everything else leaks enough you can't tell which seal might leak.
Is there a rebuild kit available or do you have to piece the gaskets together? Did I read something about shimming the pump to bring it back to life? Is there anything else I should do to it while it is out?
 
I have the pump out of my MD also. I don't know a lot about this but I'll chime in anyway. There's not a whole lot to these pumps- a couple of gears that do the pumping, and a seal around the shaft that is a common leak - easy to fix with a new neoprene seal. Your gears could be worn to the point where enough pressure cannot be built up. I don't think they are replaceable with new, but am not sure. You could try to locate another pump. Just my .02.
 
You must log in or register to reply here.

Similar threads

O
  • Question
53 jd 40 leak at control shaft is there any way to put a seal on it without taking all apart?
Replies
3
Views
145
deeretails
D
B
hydralic pump air test fail
Replies
4
Views
280
Bigtoe71
B
D
Farmall 300 clutch update
Replies
4
Views
221
used red MN
U
B
Farmall 806 3 point lift problems.
Replies
5
Views
488
caterpillar guy
C
M
Massey TO35 the lift arms vibrating
Replies
0
Views
76
mossdm
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top