(800) 853-2651
SHOP NOW

Dropped the oil pan

F

Farmall-H

Member
Hey guys,

I dropped the oil pan on my super a and was wondering what to look for to determine if the sleeves and o rings look good? It seemed that at the bottom of the sleeves,there was some rubber material almost silicone like around the edge of the sleeve. Is that a sign of a previous rebuild?

Thanks,

Cole
 
most likely. if you have no coolant in oil why not just do a compression check? then the next step is pull head. your starting at wrong end of the horse.
 
I just dropped the oil pan to clean any sludge out and decided to look at the sleeves. I am not interested in pulling the head if i dont have to.
Runs fine and doesnt smoke.

-Cole
 
I just dropped the oil pan to clean any sludge out and decided to look at the sleeves. I am not interested in pulling the head if i dont have to.
Runs fine and doesnt smoke.

-Cole
 
with one piston at TDC look at the wall of the sleeve. See if there is a ridge where the rings stop. A compression test will also tell you what shape your rings are in.

As long as you have the pan off, you could check the main and rod bearings with a little plastigage.

Greg
 
You must log in or register to reply here.

Similar threads

C
1953 Super H water in oil
2
Replies
25
Views
1K
used red MN
U
grandpa Love
Coolant in oil pan
Replies
12
Views
566
rustred
rustred
B
100 farmall mixing oil and water
Replies
7
Views
178
13fx
1
C
Re: 1955 Farmall 100 Engine Overhaul
Replies
12
Views
840
teddy52food
T
C
1947 ford 2n oil pan
Replies
3
Views
274
Kirk-NJ
K
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top