Anonymous-0
Well-known Member
Where should the voltage regulator on a 39 M be located? Does anyone know of a basic wiring diagram for a 39 M with magneto?
- Thread starter Anonymous-0
- Start date
Anonymous-0
Well-known Member
The 39 M didn't come with a voltage regulator. Instead they had a cutout relay mounted on top of the generator. Charging was controlled by a switch on the dash. High charge full fielded or grounded the field circuit. Low charge ran the field circuit through a resistor in the switch on the dash.
Anonymous-0
Well-known Member
Okay. The M that I bought has a regulator mounted on the side rail in a crude fashion. I was thinking of putting back to original or mounting it on the bottom of the steering post. I need a diagram to sort things out.
rustyfarmall
Well-known Member
You can get a saddle mount regulator that sits on top of the generator, just the same as the original cut-out relay. Otherwise, get a flat mount regulator and mount in the rear fuel tank support, right in front of your feet.
John M
Well-known Member
- Location
- Nunyafn business
On a 39, it should be a cutout, but it should mount on top of the genny, not the gas tank support, if youre going for originality, otherwise, anywhere with a good ground will work.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy