Farmall 560D transmission mounted hydraulic pump

Chaz D · Nov 23, 2010

Hi all,

I am looking to replace the hydraulic pump mounted on my International Farmall 560D tractor, but my manual completly skips that part, and I need a little help on how to remove it. Anyone have any instructions/diagrams they could post for me? It would be a BIG help.

Thanks a lot,

Chaz

Aces · Nov 24, 2010

Chaz drain all the oil that will drain out the plug under the TA housing. Then remove the lines from the plate on left side of the TA housing. Then remove the 3/8" size capscrews from around the out side of that plate, the plate has dowel pins so it might come loose a little hard, the 2 pumps will come with the plate. The pump with the drive gear is the hyd pump the piggy back is for the power steering. Hope this helps.

Chaz D · Nov 24, 2010

Ok, I'll see if I can get it done. Thanks a lot for your help!

Chaz

Heat Houser · Nov 24, 2010

I believe there were thick and thin gaskets used to set the drive gear backlash. Measure the old ones before you throw them away.

Farmall 560D transmission mounted hydraulic pump

Chaz D

New User

Aces

Member

Chaz D

New User

Heat Houser

Member

Similar threads