(800) 853-2651
SHOP NOW

Farmall 300 LP

P

Phil Eastman

Member
I recently acquired this 300 Farmall. It has been sitting for a couple of years. I am not able to get spark to the distributor. I have a new set of points and condenser I want to install. I don"t see anyway to do this other than removing the distributor. Does anyone have any experience with this tractor and know what I need to do to remove the distributor and reinstall? Is this tractor similar to the H? This is my first Farmall and my first LP fuel system. Thanks for any help.
 
I am confused do you have a photo of the distributor in question. (sounds like you may have a magneto)Either way distributor or mag the points are under the cap. NO reason to remove the entire assembly for that.
I thought the H and 300 were close if not the same. My 300LP is the same as all my H's. Fuel system has nothing to do with no spark as all 300LP's were conversions anyway.
 
Thanks for a reply. I"m well aware the fuel and ignition are separate. It is a distributor but there is so little room. maybe I need to remove the hydraulic lines for more room?I didnt think i could do a good job with out removing the distributor. Thanks.
 
when you say 300 LPs were conversions. This looks like a factory installation. It has LP on the hood like the farmall and 300.
 
I am no expert but I understand that all the 300's were factory gasoline and dealer (or later) conversions to LP. Here is the best photo I have of mine at the moment. I'll try to get a few of the LP system tomorrow if you want.

Pulling the distributor is not really a problem just make sure you mark the rotor position before removal. Then be sure to get it back in the same spot. it's been a while since I did mine and the only thing I remember is the loader was in the way.
again I can look at it in the light of day, and possible be of more help then.

Ken
300.jpg
 
You must log in or register to reply here.

Similar threads

M
Super M distributor
Replies
6
Views
416
matthies
M
3
300 Farmall Hydraulic help
Replies
10
Views
585
dewy
D
R
6-12 volt update points conversion?
Replies
17
Views
585
Janicholson
Janicholson
T
Farmall 300 misfire?
Replies
16
Views
541
redforlife
R
M
464 ignition
Replies
9
Views
459
MWP
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top