Sam Eubanks
Member
I purchased a rebuild kit for a 1951 Super AV. The kit included pistons, sleeves, etc. I now have a suspicion that I have the wrong sleeves. When I insert them into the block, they seem very loose. Because of the taper in the sleeve, they will not fit snug against the rubber washer used to create the wet seal. Should the sleeves fit snug against this O-ring in order to create a wet seal? I was expecting the sleeve to be a snug fit throug both cylinder openings in the block rather than just the top.
I acknowledge that my terminology may not be correct. Any advice would be appreciated.
Sam
I acknowledge that my terminology may not be correct. Any advice would be appreciated.
Sam