(800) 853-2651
SHOP NOW

Well I drove the BA today

O

old

Well-known Member
Location
Camdenton Missouri
Well if you call putting it in first gear and moving it 5 feet or so driving it I did. LOL Still have to put the radiator on it and wire it but figure I'll do the duals on the one side and a few things like that before I do the wiring etc. It is sort of funny how it runs so much better when you have the firing order 1,3,4,2 instead of 1,2,4,3. LOL. Runs nice and smooth just wish I could get the float needle in the carb to seal like it should. Guess I will have to open it up again and see if setting the float so it closes fast will fix the problem
 
rich, are you gonna fluid load the rear tires? i put 5 lb/gal cacl in the rears on my b, made a whole different tractor out of it. pulls a 2-12 little genius real nice. i need some weight in the front of it tho, it is a wheelie poppin little tractor.
 
No I do not plan to put fluid in any of the tires but will/have wheel weights that I will be putting on. Have on the right side a cast center and a wheel weight on now did the weight today and boy does it hurt if you get your fingers between the weight and the cast center LOL. I have to put the weight on the other side and will be posting pictures of the progress in a few minutes
 
You must log in or register to reply here.

Similar threads

R
Fuel issues with 1936 F12....I think.
Replies
15
Views
671
Rob41
R
W
Farmall A hard starting - fueling issue
Replies
14
Views
663
C.Amick
C
M
450 Farmall update ignition
Replies
5
Views
366
gene bender
G
K
1850 Gas Flooding
Replies
7
Views
464
J.Wondergem
J.Wondergem
B
Unusual symptoms, needle valve restriction?
Replies
14
Views
1K
BarnyardEngineering
BarnyardEngineering
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top