(800) 853-2651
SHOP NOW

Hillside hitch installation

T

TxMDTA

New User
I have a hillside hitch that I would like to install on my Super M. I have seen a few in photos and one on a 450D, but cannot remeber how it actually fits onto the u-shaped drawbar.
Does anyone have any knowlege and / or photos of how this is supposed to be placed? Thanks. I will add a photo.
a24476.jpg
 
The part you have bolts to the outside of the drawbar, and a rod [that you don't have] goes to the swinging drawbar. The handle moves the swinging drawbar up to ajust for the hillside.
 
Your lever is not for an M or SM. It looks very similar but not identical to the lever for an F-12.

p50648.jpg


The one on the left is for an M, the one on the right is for an F-12.

You could cut it up and make it fit, or sell it to someone who can use it. I made one using the land lever off an #8 plow. Mine is much more precise than the factory hill-side hitch. The factory hitch is too course.
 
IHCPloughman,
No wonder we couldn"t make heads or tails out of it. I appreciate you pulling out your manuals and doing the research.
 
Bill,
Thanks. I do have the extra part that attaches to the drawbar. Unfortunately, it is for the wrong tractor (F-12 instead of SM). I thought it was shorter than the one I had seen before installed on a 450D. Darn.
 
You must log in or register to reply here.

Similar threads

crsutton81
5140 hitch controls
Replies
3
Views
132
crsutton81
crsutton81
D
Rear mount sickle mower for Super C w/ mid mount belly mower
Replies
6
Views
486
gene bender
G
A
Super C Fast Hitch
Replies
10
Views
438
ajhbike
A
E
Clutch release sleeve on Super C does not stay in place
Replies
15
Views
771
used red MN
U
S
Towing a trailer with 3 point hitch
Replies
11
Views
647
John Schoenauer
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top