Farmall A Oil Plug

FM · Oct 20, 2010

Is the oil pan plug in an A special or can Napa set me up? What should I tell them I need when I go?

Already put the pan on the tractor and don't really want to take it off again.

Mike

old · Oct 20, 2010

It is just a standard run of the mill pipe plug that any hardware store should have on hand

ScottyHOMeY · Oct 20, 2010

Mike, that plug is pretty much a standard plumbing item -- a 3/4"NPT pipe plug. I've seen 'em all three ways -- square-head, recessed head, and hex. Any one of 'em will work, though that square-head is real handy to get a wrench onto.

FM · Oct 20, 2010

Thanks guys! How about the plug in the lower water elbow?

Mike

ScottyHOMeY · Oct 20, 2010

If you're talking about the drain plug on the underside, I can't swear by that one. It might be 1/4", but I'm pretty sure it's 3/8" NPT

old · Oct 20, 2010

I too think it is 3/8 but can not say 100% sure and would you believe I just had part of one in my hand either today or yesterday

big fred · Oct 21, 2010

I seem to recall it was 1/4 npt on my B, but last time I looked at it was probly 6-8 years ago.

gene bender · Oct 21, 2010

3/8 pipe then a 45 elbow and a short nipple with a cap. Now if you are never going to drain you can use a plug but how will you get it out if you want to drain the coolant.

Farmall A Oil Plug

FM

Member

old

Well-known Member

ScottyHOMeY

Well-known Member

FM

Member

ScottyHOMeY

Well-known Member

old

Well-known Member

big fred

Well-known Member

gene bender

Well-known Member

Similar threads