(800) 853-2651
SHOP NOW

IH 824 three point hitch ...

M

marty g.

Member
Neeed advice for the 3 pth. We were ploughing with a 4 furrows, then it did not want to go down, it was stuck in the air. Got tractor home. It eventually seeped down but its still not functionning, raising. Lots of oil in it, I can see oil flow with top cover off.
Where do I start?
 
Hi Marty, not familiar with 826 but there is probably an unloading valve somewhere that has its orifice plug. On the 74 series tractors the unloading valve is a large plug under the seat with an orifice in it.
Try dead heading one of the remotes to see if this will blow the dirt out.

JimB
 
Hey Jim,
I tried dead heading the remote a few times without success. I did unscrew that big plug under the seat only to see a long spring come out but screwed it back before losing something.
Just got a diagram for this so I'll look at it again.
Thanks for your time Jim.
 

If it's an 824 it's a german IH, similar to an 844. Lots of those sold in Canada.

826 is a totally different tractor.
 
Yes it is an 824, not 826, German made, very similar to the 844. Is the 3 PTH similar to any British made?
 
You must log in or register to reply here.

Similar threads

K
601 workmaster 3 point problems
Replies
1
Views
384
RDobbs
R
C
1965 Massey 175 3-point Hitch Problems
Replies
15
Views
487
cabot
C
O
806 2 point hitch not working right
Replies
12
Views
410
Janicholson
Janicholson
S
John Deere A can't get the 3 point hitch to go up
Replies
6
Views
588
used red MN
U
A
IH 384 Diesel
Replies
11
Views
401
JimB2
J
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top