WD-9 Hood

meihman · Sep 11, 2010

What is used to hold it in place?

Wardner · Sep 11, 2010

The same spring-loaded clips as used on H and M.

meihman · Sep 11, 2010

Thanks, mine didn"t have anything attached to it.

Farmaller · Sep 12, 2010

They have T-bolts with nuts and washer that hook into the fuel tank and grill. You should have slots inside the hood for the T-bolts. Don't believe everything you read.

CNKS · Sep 12, 2010

Far as I know Wardner is correct.

Wardner · Sep 12, 2010

Yes, you are quite right about the bolts. I guess I have been walking by several M hoods too often in my barn recently.

I have 3 nine series tractors. It's a wonder I didn't check my parts book before responding. I normally do on this type of question.

WOpp · Sep 12, 2010

My parts book shows Serial# 501 to 1439 used hook and spring like H & M above that they used T bolts a small bracket and washer and nut, yhere is a slot for the T bolt to slide into .

WOpp · Sep 12, 2010

My parts book shows Serial# 501 to 1439 used hook and spring like H & M above that they used T bolts a small bracket and washer and nut, yhere is a slot for the T bolt to slide into .

meihman · Sep 12, 2010

I actually should have asked what is correct. I have 2 T-bolts that came with the tractor but i thought they were something that someone had made up. i use them. i have found mixed thoughts on what is factory & what is not. i'll have to make up a couple of more with threaded rod.

WD-9 Hood

meihman

New User

Wardner

Well-known Member

meihman

New User

Farmaller

Member

CNKS

Well-known Member

Wardner

Well-known Member

WOpp

Member

WOpp

Member

meihman

New User

Similar threads