Super C PTO Housing Removal ?

dpski · Aug 17, 2010

I need to regasket the belt pulley and PTO housings on my SC, leaking pretty bad. Just took the top of the tranny off to do the same to the driver platform/tranny cover. Any special tips or tricks for removing the belt pulley and pto housings or just unbolt them from the tranny case?

Dave_Id · Aug 17, 2010

The housing leak comes from a very large small diameter o ring. I could not find a replacement, so I removed the belt pulley assembly and replaced with the cover that used just a gasket.

dpski · Aug 18, 2010

Removed the belt pulley housing and PTO unit. O-Ring actually had a chunk missing from it. Not sure it's really an O-Ring, or more like a square rubber seal. Local IH dealer said not sure they can still get, didn't have any. P/N showed a price, but could be a goose chase. Went to a local hydraulic supply shop and they had an O-Ring that's pretty darn close, not an exact match, but since nothing is actually rotating within the O-Ring it should be o.k. I'll find out.

In the PTO housing there's a square openining that goes all the way through the PTO housing and then opens up into the belt pulley housing. I assume some sort of oil passage. I'll try to post pictures later.

Super C PTO Housing Removal ?

dpski

Member

Dave_Id

Well-known Member

dpski

Member

Similar threads