(800) 853-2651
SHOP NOW

I-12

B

BPB

New User
I am working on an I-12 that is rough. Engine stuck. Clutch frozen. How do I pull the engine? 4 bolts at rear are out. Front mounts are free. Steering gear is off. Clutch should come out with the engine. Splined shaft seems to be frozen to clutch. Any suggestions?
 
i presume u are aware of the dowl pins in the bell housing. if the shaft is stuck in the disc u should be able to undo it at the trans. and remove everything as a unit.
 
You need to make sure all the bolts are out and it may have dowels that's keeping it tight on both sides of the bell housing. It may need some prying. Make sure you have that engine well supported. Hal
 
As El Toro pointed out - might need some prying.

One thing to keep in mind is being safe - that old iron is heavy so make sure everything is going to be supported when it all come apart- better to have a few back-up supports than to get hurt.

Good luck.
 
that tiny little engine can be pretty lifted out by hand. use a good lifting sling and no worries. biggest thing is dont drop the flywheel on your feet.
 
Thanks for all of your replies. Best advice was make sure all of the bolts are out. Is there a source of gaskets or perhaps a sleeve set for this tractor?
 
You must log in or register to reply here.

Similar threads

J
international TD 12 won't turn right
Replies
2
Views
447
2x4
2
M
450 power steering unit
Replies
2
Views
525
Mike Fitz
M
D
560 D no start
Replies
7
Views
658
Dieseltech
D
F
IH 484 Loader Tractor
2 3
Replies
47
Views
2K
MARK ROBKE
M
1
cockshutt 1650
2
Replies
27
Views
2K
cjunrau
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top