(800) 853-2651
SHOP NOW

Farmall 806LP engine

A

Anonymous-0

Well-known Member
I have a a Farmall 806LP. The engine is stuck. Does anyone know if a 706LP would fit or possibly any other engine from a combine, cotton picker or the like? I believe the 806 had a 301cubic innch motor and the 706 had a 291cubic inch motor.
 
Only the later 706s had the 291 engine. The rest had the 263.

The 301 did not have sleeves, the 291 and 263 did.

LP pistons might be different than gas. You might want to find a parts book before going too far.
 
ive got an 806LP. heres what ill tell ya


if you want to replace the whole engine, a 291 and a 263 will bolt in and work. cant mix and match any parts with a C301 since its sleveless.

an 806LP engine is a C301 which is exactly the same as a gasser tractor. HEADS ARE THE SAME!!!! pistons are the only thing different with just SLIGHTLY higher compression, not much

an engine out of a 715 combine will fit, you just need to use the front cover of the the tractor engine. your toolbox will not work if you use the combine engine since the front moutning bracket will not have anywhere to attach. the boss is nonexistant on the combine engine, so no where to thread a bolt in



HAVE FUN!!
 
A caviat on a 806LP. Be sure to have hardened valves and seats installed. We have a 806 that was converted from gas to LP and after overhauling the valves went out shortly.
 
You must log in or register to reply here.

Similar threads

B
Farmall 340 Engine
Replies
4
Views
371
gene bender
G
J
Bill gears
Replies
3
Views
380
Jim Becker
J
M
Farmall 140 Cylinder gets tight after one minute of running.
Replies
17
Views
629
560Dennis
560Dennis
J
Ford 600 Series Engine Rebuild
Replies
8
Views
514
kenbob
K
crsutton81
Farmall 140...what's it worth ?
Replies
7
Views
392
crsutton81
crsutton81
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top