Anonymous-0
Well-known Member
Hello, I have a 300 utility and a 350 utility,both seem to gain oil,I am wondering if I may be getting hyd. oil through the pump into the block,Any others have this problem? thanks
- Thread starter Anonymous-0
- Start date
Janicholson
Well-known Member
Andrew is on it. The search for archives have hundreds of posts on the topic. There may be two different pumps, so some review might be good.
The seal is on the shaft between the oil fill hole, and the pump. Either a conventional seal, or a "O"ring. If an "O"ring, and the shaft is grooved, the housing may need to be recut to allow the speedy sleeve to fit. Jim
The seal is on the shaft between the oil fill hole, and the pump. Either a conventional seal, or a "O"ring. If an "O"ring, and the shaft is grooved, the housing may need to be recut to allow the speedy sleeve to fit. Jim
Anonymous-0
Well-known Member
Thanks for your replies
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy