(800) 853-2651
SHOP NOW

Char-lynn on super MTA

A

Anonymous-0

Well-known Member
When you put the motor in the bracket where the gauges are is there some sort of shims to make it line up with the shaft. I have the proper wobble joint connector but when you start drawin the bolts down it puts a strain on it.Any one with a picture of whats right? Just dont want to knock out the seal.Thanks
 
It's round and wedge-shaped as in thicker on one side than the other since the steering shaft is angled different than the bracket.
 
There was a replacement gauge bracket that came with the char lyn kit. SOme guy on ebay has them and I think OEM has them now also.

Gordo
 
If you will go to Steiners web sight they have the bracket that is right for the M's. I used one in the spring for my '53 Super M. The mounting holes that form a triangle - the 2 at the top are threaded for 3/8 nc and the one at the bottom is for a regular 3/8 bolt and nut - but the bottom hole did line up and I used a grade 5 5/16 nc. What I understand if the shim is for the H - my M did not require the shim. James
 
You must log in or register to reply here.

Similar threads

F
Super mta engine id
Replies
4
Views
1K
D Slater
D
F
POWER STEERING ON H
2
Replies
25
Views
2K
Frankenford1
F
C
MNGB they are char-lynn valves on the m5
2
Replies
21
Views
2K
MMDEL
M
D
Char-Lynn on a 300 RC
Replies
6
Views
956
dewy
D
C
Starter Nose Exploded on Farmall Super M
Replies
7
Views
2K
Tom Dowling
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top