Truckingthumbtack
New User
I read on here once before about someone had made liner removal tool for the liners on an A. Can some one post a pic of one or dimentions of one I could build? Thanks!
- Thread starter Truckingthumbtack
- Start date
Here's Keith's sleeve puller. You will need to measure the sleeve bore since it could be 3.00" or 3.125" then have the puck undercut .020" to clear the bore. You can drive out those sleeves with a piece of oak and big hammer since they're wet sleeve's and are not pressed in. Hal
PS: Once you have the sleeves out you need to clean that block area below where the old seals were installed,
PS: Once you have the sleeves out you need to clean that block area below where the old seals were installed,
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy