i have a super h that broke the front bolster shaft. the only place i could find a replacment was herschel adams. the only part i can tell is differant is the large part below the thrust bearing. the old one looked to be beveled, with a beveled spacer to match. the new one has no bevel, so i left the spacer out. problem is that the gear on the top will not tighten down on the shaft, it tightens to the housing first. has anyone had this problem? my plan was to just snug the nut and not tighten it unless someone out there knows what to do!!
- Thread starter jcwag
- Start date
Janicholson
Well-known Member
If all the pieces are correct, it should tighten as it was before. I would not run it with the nut loose.
If the lower bolster is on it could have the long bolt in the wrong hole. It could have two spacers on it if one was stuck to the tractor, Look in caseih.com for the parts break down to see what should be there. Jim
If the lower bolster is on it could have the long bolt in the wrong hole. It could have two spacers on it if one was stuck to the tractor, Look in caseih.com for the parts break down to see what should be there. Jim
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy