International A Shifting Lever

Larry Hardesty · Jul 10, 2010

The shifting lever on my 1946 International A is worn badly and the gears occasionally jam. Anyone have the dimensions to weld/build up the piece on the end that fits into the runners? The parts manual looks like a small ball on the end, but mine is completely flat with a bit of a taper, so probably very worn...only 64 years old!

Thanks in advance

Larry Hardesty

Janicholson · Jul 11, 2010

When looking from the side, it is circular, from front or back, I think it is flat. It should be just smaller than the width of the rails (left to right) and just round enough to fit the slots (which might be worn as well) bigger can be adjusted on a grinder to be just right. Jim

Larry Hardesty · Jul 11, 2010

Thanks much. I will see if I can get a measurement of the slots.

Bookman

International A Shifting Lever

Larry Hardesty

Member

Janicholson

Well-known Member

Larry Hardesty

Member

Similar threads