clutch 3414 or b414

woodslip · Jul 8, 2010

hi all
neat site...hoping for some great help....have a 3414 that starting to give my trouble.....the cluctch is not dissingaging ......as i have to idle it down in order to get out of gear....i press the clutch and she wants to keep moving....then cant get her back in gear.....less i idle down ....and when i get it into gear again it jumps forwards a bit....thanks for any help....woodslip

also if i leave pto off she shifts just fine

just saw a site that said if low on fluid the clutch would not disingage

JimB2 · Jul 8, 2010

Hi, is it a two stage clutch? Half way down, transmission stops, all way down the PTO stops.

JimB

woodslip · Jul 8, 2010

thanks jimb...so you think she shot?????

JimB2 · Jul 8, 2010

Hi, my guess wood be the pilot bearing is dry of grease and continues to spin the transmission shaft. There is no lube point for pilot bearing. Only solution is split tractor and replace. This is more difficult clutch repair as this is a two stage clutch. There is a large transmission clutch and a smaller PTO clutch.

There is a clutch/foot pedal adjustment and adjustment of fingers on the pressure plate. Usually if the clutch/foot pedal or fingers are out of adjustment the first problem will be the PTO will be difficult to engage and PTO continue to run with clutch pedal all the way to floor board.

JimB

clutch 3414 or b414

woodslip

New User

JimB2

Well-known Member

woodslip

New User

JimB2

Well-known Member

Similar threads