James Williams
Well-known Member
Is the steering universal near the gear box replacable by just changing the universal or do you have to cut the rod and insert a new joint and reweld
jimmy
jimmy
- Thread starter James Williams
- Start date
Bill Hires
Member
The U joint is riveted to the shaft and easy to remove, unless it has been welded on.I have used two oil seals instead of a wear sleeve.
gene bender
Well-known Member
Remove the pins they will drive out. The problem will be removing the joint from the steering sector and the steering shaft. You will need some good heat on both ends. Both ends have a woodroff key. The replacement could have a different way of mounting just depends on where you get one. It will not be like the original and cost around 45 and up.
gene bender
Well-known Member
Over the yrs iv had and sold many Bs and have never seen one that has the u-joint riveted. So where do you come up with that. How many have you replaced or fixed.
James Williams
Well-known Member
Gene,When I asked the question I never seen the tractor,Im familar with the F series.Since than I found out that it has roll pins in it.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy