(800) 853-2651
SHOP NOW

H Carb Bolt

C

Chad504

Member
I decided to rebuilt my carb over the weekend and I realized that the front bolt that attached the upper an lower halves is missing. the two rear ones are still intact. Before I put it back together, does anyone know what size and length I need?
 
(quoted from post at 06:17:08 07/06/10) I believe all three are the same size.
12x24x7/8"
Click to expand...

12x24x7/8" is correct but you will probably not find the 7/8" length. Just get a 1" length and hack-saw off about 3 or 4 threads.
 
Yep do as Rusty says but be sure you get a nut or 2 with the bolts so before you hack saw the end off you put 1 or 2 of the nuts on. Do that and then removing them helps clean up the treads so it will then screw in easier
 
Try the 1 inch. Put the washer on it and screw it in. The threaded hole is probably deeper than 7/8.
If the 1" bolt is too long you know what to do.
 

Yes, Fastenal has them. That's where I get mine, but they come in either 3/4" or 1" lengths. I buy them 100 at a time.
 
Quick and easy if you have a wire stripper/crimper tool they usually have 3 holes for nipping screw for panel boxes!!!!!
 
You must log in or register to reply here.

Similar threads

B
2606 carb doesn't fit right
2 3
Replies
42
Views
925
bc
B
W
Farmall M Carb.
Replies
4
Views
439
WiJay
W
3
Farmall H Carb
Replies
5
Views
277
Rich'sToys
R
K
weird oil coating on a fresh rebuilt H carb
Replies
10
Views
650
BarnyardEngineering
BarnyardEngineering
C
Farmall H front tires
Replies
16
Views
754
caterpillar guy
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top