(800) 853-2651
SHOP NOW

cub with governor issue

B

brooksie

Member
My cub runs at a high RPM only as I cannot adjust the carb/governor shafts. I can lower the RPM temporarily at the the carb but the governor then revs the motor back up. Is it possible something is frozen in the governor? The governor shaft in the front of the tractor does not move when I adjust the throttle shaft.

Thanks for any help. I accidentally posted this in another forum here before I found this one. I am sorry if I broke a rule.
 
No rules here on that topic.
If the governor output shaft (and linkage is not moving, you are going to need to go into the governor. Do not allow it to run over speed, as there will be drastic damage. If the link from the throttle control lever is moving the lever on the governor through its full range, it is internal to the governor. They can have any problem from broken springs to bad bearings, to weights off of the spindle. A manual is needed. caseih.com has a parts diagram on line. Jim
 
Make sure all linkage to the governor moves freely. Oil all joints. Make sure the governor spring (located above governor housing) is fully relaxed when the throttle lever is all the way back in the slow idle position.
 
You must log in or register to reply here.

Similar threads

G
Super A governor adjustment
Replies
5
Views
292
560Dennis
560Dennis
B
Ford 300 over-rev on startup
Replies
2
Views
159
Fordfarmer
F
G
Super M with Chevy V-8 Governor
Replies
9
Views
644
Tramway Guy
T
S
8N Governor issue?
Replies
8
Views
479
ShawnPalichuk
S
K
1929 GP Throttle/Governor Issue
Replies
1
Views
294
ET
E
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top