I got new bands put on my 48 H. Now, the spring linkage that connects the pedel to the brake band shaft wont reach each other. Their 8in apart. Ive got the keyways matched up,But the shaft that goes from the brake bands on its other end is right against the bottom of the floor plate. What do I need to do. Are the brake bands, linkage, interchangeable from side to side, other than the arms that come out off of the brake band shaft band shaft. I know there different. I know ive got the toggle that the bands pin into isa right, and otherwise the keyway faces the back instead of the front.
- Thread starter Farmallb
- Start date
Janicholson
Well-known Member
I think (but am only guessing) that they are mirror parts and must be on the correct side to work. they should be just about parallel with the ground when installed. Unless your bands are short! Jim
Janicholson
Well-known Member
I think (but am only guessing) that they are mirror parts and must be on the correct side to work. they should be just about parallel with the ground when installed. Unless your bands are short! Jim
Tom Fleming
Well-known Member
Flip them around and try again. Also, did you adjust the spring clevis connectors?
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy