rogerevilone
New User
The shaft (IH calls it a pin I believe) that the hi lo range yoke is mounted on is broken at the 5/16" retaining bolt. Is there any way to install a new one without splitting the tractor? Can it be accessed through the rear axle housing somehow?
I believe a two piece shaft could be made and installed from above. Any thoughts on that?
Also the back section of the pin got pushed backwards into the rear housing. Would it have gone to the bottom? Will is cause more breakage?
Thanks,
Roger
I believe a two piece shaft could be made and installed from above. Any thoughts on that?
Also the back section of the pin got pushed backwards into the rear housing. Would it have gone to the bottom? Will is cause more breakage?
Thanks,
Roger