Tips on pulling a Bosch pump?

Kelly MT · Jun 24, 2010

I need to pull the Bosch VA injector pump off my IH 5000 with a D239. Any tips or suggestions? PK

DeltaRed · Jun 25, 2010

Its not hard to do.Most importantly,be sure you have all timing marks(pump/flywheel)lined up be for you loosen even one bolt.

Allan in NE · Jun 25, 2010

Just curious why you have to pull the pump?

I thought those ol' gals would just about run forever?

I've got the same windrower, started acting up and I just knew it was the pump going south from the way it was acting. Turned out to be clogged fuel filters.

Allan

Kelly MT · Jun 25, 2010

Well It's leaking from the Head O-ring. More than I can Live with. PK

Kelly MT · Jun 25, 2010

Do you have to remove the three gear/flange bolts or just the pump shaft nut? PK

JimB2 · Jun 25, 2010

Hi Do not loosen cap screws on pump drive shaft gear. Only loosen and remove the big nut on the end of the drive shaft.

Is it leaking Diesel fuel into the crankcase?

JimB

JimB2 · Jun 25, 2010

Hi Kelly,

Send me an email at [email protected] and I will email you a PDF document for removal of Bosch Injection pump.

JimB

Kelly MT · Jun 25, 2010

No, it's leaking out the top rear around the little port on the head or the head to body O-Ring. Looks like a BB in the hole. PK

Tips on pulling a Bosch pump?

Kelly MT

Member

DeltaRed

Well-known Member

Allan in NE

Well-known Member

Kelly MT

Member

Kelly MT

Member

JimB2

Well-known Member

JimB2

Well-known Member

Kelly MT

Member

Similar threads