(800) 853-2651
SHOP NOW

mounting F11 on M

D

Dick Binfield

Member
I am mounting a F11 on an M. I noticed that the nose of the tractor is off to the left side of the loader. Upon looking at the angle braces which bolt to the frame channel I noticed the left side angle is an inch shorter than the right side. To center up the loader on the frame I need to lengthen the left brace adjustment by the amount it is short. My question is After I take the left angle brace loose can I hook on the to frame of the loader up at the head (just back of the bucket mounts) and gently move it over untill it centers up or do I have to dismount the unit from the M and start all over???
 
yes you can 'adjust' the loader without removing it.leave the bucket on the ground and push the loader to where it needs to be.those braces should be adjustable
 
My personal opinion about the best way to adjust a F-11 is with a cutting torch. First thing I did with my MTA when I brought it home was take that loader OFF. It ended up it the scrap heap.

But you know what the say about opinions...

Ben
 
You must log in or register to reply here.

Similar threads

D
M rear end
Replies
10
Views
1K
Whiskey Bent
W
D
Need help: Farmall M and Koyker Super K Loader
Replies
8
Views
725
Dakota Farmall
D
3
2pt-3pt conversion ? on 300 U
Replies
16
Views
427
BarnyardEngineering
BarnyardEngineering
D
Farmall M with 1701 Ldr
Replies
11
Views
744
the tractor vet
T
M
1964 Ford 2000 Industrial - without PTO, without 3-point - any need for hydraulic reservoir under seat to be filled?
Replies
8
Views
382
Sean in PA
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top