(800) 853-2651
SHOP NOW

Attaching Woods L59 mower to Super A

B

beanpole

New User
My husband has been waiting 6 years to own a super A. We finally found one, and now are getting excited to use it. Problem is we can"t quite figure out how to mount the woods belly mower to the super A. We have been scouring the internet for some instructions or some good pictures just to show us how to mount it. If anyone can help out with some instructions or pictures they would be greatly appreciated. You can email me at [email protected]

Thanks
 
I have the manual, but we still can't figure out where the mount with the 2 pulleys ends up going on it. the people we bought it from just gave us all the pieces to everything. So we have to put everything on the mower, and the manual just doesnt give a very good pic at all of it.
 
The heavy assembly with the two pulleys bolts under the back of the tractor to the final drive housings. There are three bolts each side that attach to the front mounting holes of the final drives, not the rear mounting holes where the drawbar attaches. The pulleys are on the back side. If there are stud bolts in the mounting holes on the final drive you will have to remove those and use 3/4 inch bolts to attach the pulley frame. Are you sure you have the correct manual. I mounted mine using the manual and did the same to a Cub for a friend and did not have any trouble.
 
Here's a pic for ya of the pullys. This is on an A, super As are the same, I have two as well.
a17348.jpg
 
Thanks so much. this is SUPER helpful. The picture in the manual just couldn't be made out and this one is great. Thanks again
 
You must log in or register to reply here.

Similar threads

F
International C-3 Mower on a C
Replies
6
Views
301
toothpick
T
D
Rear mount sickle mower for Super C w/ mid mount belly mower
Replies
6
Views
473
gene bender
G
P
300 u 6 volt gen to 12 volt alternator condition question
Replies
8
Views
468
Paul 300 U
P
C
Putting a woods L59 belly mower on a farmall BN
Replies
6
Views
499
grandpa Love
grandpa Love
P
WD-9 engine to a super WD-9 specs?
Replies
5
Views
453
D Slater
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top