Priming 2444 Hydraulics

fyr808 · Jun 11, 2010

My son and I just completely flushed all hydraulic fluid out of the 2444 due to bad water contamination. We pulled the bottom drain on the rear end, removed and cleaned lift housing, rinsed and blew out all of the lines, steering rams, and loader rams. We started it today and it won"t prime. No rear lift, steering, or loader movement at all. Any help would be appreciated.

JimB2 · Jun 11, 2010

Hi did you clean the suction filter? Drive the tractor into a ditch where the front wheels are much lower than the rear. If that does not work, remove the hydraulic filler plug and with air gun and a clean cloth to seal around the air gun stick it in the hydraulic filler hole and slightly pressurize the reservoir.

JimB

fyr808 · Jun 11, 2010

Thanks

Priming 2444 Hydraulics

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

fyr808

Member

JimB2

Well-known Member

fyr808

Member

Similar threads