FARMALL M GOVERNOR

Anonymous-0 · Jun 6, 2010

I HAVE A STIFF SPRING IN IT ,PULLED IT LAST WEEK AND ITS GOES TO 1900 RPM'S , WHEN YOU LEAVE THE THE LINE ITS ON THE GOVERNOR , UP ND DOWN , UP AND DOWN AND THEN WHEN THE SLED COMES ON TO YOU ITS SETTLES DOWN AND RUNS ABOUT 1795 RPMS, GOT HOME TOKK THE GOVERNOR PLATE OFF BECAUSE I WANT TO INCREASE THE RPMS TO 2050 BUT THERES NOT ADJUSTMENT ? THE STOPS AND ADJUSTMENTS THAT YOU NORMALLY USE TO DO THAT ARE THERE BUT NOT BEING USED? DO I NEED TO ADJUST THE VERTICAL SHAT HOUSING ?

Janicholson · Jun 6, 2010

Ask over on the pulling board, they will have answers. On the left select discussion forums, then select Pulling from the function section. Jim

sflem849 · Jun 7, 2010

It if pretty common to see the RPMs hunt with little load when you put a stiff spring in the Farmalls. Guys in my club say they haven't seen a decrease in performance, but it is annoying.

FARMALL M GOVERNOR

Anonymous-0

Well-known Member

Janicholson

Well-known Member

sflem849

Well-known Member

Similar threads