(800) 853-2651
SHOP NOW

leaking seal

A

Anonymous-0

Well-known Member
what would cause a seal on the transmision shaft where it comes into the bell housing and conects to the clutch to leak installed two seals a speedy sleeve on shaft and still leaks. Is there a posability that a return hole for the oil to the bearing be plugged??? any help would be great.
 
Is the bearing good? If the bearing is worn and has play, you won't be successful in getting the seal to hold. Also, don't know what tractor you are talking about, but on most IH tractors, the seal at tht front of the transmission runs on the clutch coupling, not directly on the shaft. Even if the seal is good, oil can still leak between the shaft and the coupling part and come out around the washer and bolt that hold the coupling on the shaft. There is supposed to be a gasket under the washer to prevent this from happening.
 
yea we got it fixed, now we have the tractor apart at the bell housing and working on a bent shaftthat goes in to the trans, thats why the seals wont hold. just a little reminder of where the tractor once was (fence row) but we willget it back right soon. Cant waite
 
You must log in or register to reply here.

Similar threads

B
Leaking control lever on McCormick B450
Replies
5
Views
129
Jim Becker
J
T
Hour counter leaking on IH B250
Replies
0
Views
77
Ted's place
T
G
'63 super dexta input shaft seal
Replies
6
Views
248
kb46852
kb46852
R
Super C clutch pilot bearing
Replies
7
Views
454
Roger46
R
B
Ford 2000 PTO shaft seal leaking
Replies
2
Views
185
Bennett French
B
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top