Wide C Front end Stop

Ted Womack · May 19, 2010

I am looking for a set of the stops or stop arms for a wide front C. I think one mounts on side of the frame for the steering axle to bump up against if tractor is tilted. Need one for each side.
Any questions, please ask.

ScottyHOMeY · May 19, 2010

You're right, there's one on each side and they bolt up to the underside of the front casting. Easy enough to fabricate. Mine went away with my wide front, but they're on the order of 3/8" steel, about 1-3/4" wide, overall maybe 9" or so long. rounded out on the front edge, long enough to extend across the rubber bumber caps, and two holes each to bolt them up with. That and two 1/2"NC x 1-3/4" bolts on each side to hold 'em on with.

Keith-OR · May 19, 2010

they're 5/8 thick x 2" W x 12"in long.

Keith & Shawn(Gold Medal winner)

ScottyHOMeY · May 20, 2010

Good job, Keith. My memory was comin' up a little short!

mkirsch · May 20, 2010

Yup, they are dead easy to make from some flat plate. Cut 'em to length, drill two holes.

Wide C Front end Stop

Ted Womack

Member

ScottyHOMeY

Well-known Member

Keith-OR

Well-known Member

ScottyHOMeY

Well-known Member

mkirsch

Well-known Member

Similar threads