Identify and purchase bearing and seal help?

I am looking for the following replacement bearings and seals for my 1951 Farmall Model H. Since I do not own a parts manual for my tractor, I was hoping someone might help me with the part numbers and a good place to purchase the parts. While the engine is running, the tractor leaks 90Wt gear lube badly because of these bad bearings and seals.

I need to replace the bearing and seal where the spinning shaft from the engine enters the transmission housing. I also need to replace the counter rotating bearing and seal that is located a few inches below the spinning shaft. Both of these are accessible via the belly opening from under the tractor. My tractor does not have the belly cover, I guess one of the previous owners lost it... I think it is possible the original shaft seal might have been made out of leather. Hopefully the replacement seal is a more modern type like the ones currently used on spindles and spinning shafts. It appears that replacement of these bearings and seals should be straight forward, but installation advice is also very welcome. Hopefully this is a common maintenance item and fellow forum members will have information on such.

Regards, Ron

I've got the seals you need, but I do not have the bearings. email is open.

Tear it down and take your peices to Napa, the ywill be able to cross everything. It may not be factory Case/IH, but it will work just fine.

Thanks for the post reply Rustyfarmall

Your post indicates [No Email], looks like you don't currently accept emails from Forum members?

I am sure I will need the spinning shaft bearing because it has considerable play but it is possible I might not need the seal for the counter rotating bearing. Any ideas where I might get the bearings? Can you help me with the bearing part numbers?

Again, Thanks Very Much
Ron

(quoted from post at 08:29:08 05/15/10) Thanks for the post reply Rustyfarmall

Your post indicates [No Email], looks like you don't currently accept emails from Forum members?

I am sure I will need the spinning shaft bearing because it has considerable play but it is possible I might not need the seal for the counter rotating bearing. Any ideas where I might get the bearings? Can you help me with the bearing part numbers?

Again, Thanks Very Much
Ron

Click to expand...

I am using the modern version of this forum, where my email does show up. if you are using the classic version, the email does not show up.
[email protected]

Parts section of www.caseih.com. Will be listed under the H.

Ron, rusty is simply an A&I or TISCO dealer and is drumming up business for personal gain. (Sort of against the policies of THIS site.)

THIS site has parts.

Your local CIH dealer has parts. Or, go to the A&I site or the TISCO site and locate a dealer near you.

Sorry to be a "bustard", but I'm telling you like it is!