CRANKSHAFT PULLEY

Anonymous-0 · May 13, 2010

FARMALL"C"CRANKSHAFT PULLEY WILL NOT MOVE.MY PULLERS CAN'T BUDGE IT.ANY SUGGESTIONS.

old · May 13, 2010

Check the archives and if you look enough to will find pictures of one Keith made to pull those pulleys. I uses a hyd jack and some other stuff to do the job. Or maybe you will get lucky and he will post it again for you

Anonymous-0 · May 13, 2010

just got done pulling the crank pully on my sc. i borrowed a split bearing tool and a big puller from a good friend. it took a big pipe on a half inch breaker bar. thought something was going to break. it would not budge until we rapped on the end of the puller with a big hammer. then it moved a hair. we had to repeat this till it was almost off before it startedto move easily.

abuckshot · May 13, 2010

Here's the page for Keiths puller.
http://www.ytmag.com/cgi-bin/viewit.cgi?bd=farmall&th=733506

Keith-OR · May 13, 2010

Here is where I posted my puller
Poke Here for puller

Keith-OR · May 13, 2010

Old called me and informed me you were having problems getting the crankshaft pulley off. When I started on Shawn's SC I read all kinds of horror stories on removing the lower pulley, so I set down and designed a hydraulic one to remove that stubborn thing. If ya need anymore info just email me.

Keith & Shawn(Gold Medal Winner)

Thanks "abuckshot" for posting the info where I put it on the last time.

old · May 13, 2010

LOL oh by the way I didn't hang up on you but my phone went AWOL on me. Guess it is getting pretty bad when I take the time to call you so you can make sure the guy gets the info he needs LOL

CRANKSHAFT PULLEY

Anonymous-0

Well-known Member

old

Well-known Member

Anonymous-0

Well-known Member

abuckshot

New User

Keith-OR

Well-known Member

Keith-OR

Well-known Member

old

Well-known Member

Similar threads