Rear Pulley For Farmall C

Ted Womack · May 12, 2010

Is the rear pulley the same on A and C ?. Purchased a C with no
pulley.

Haas · May 12, 2010

The pulley will fit. I'm not sure about the gear ratio, it may be different between the C and A which means the pulley speed may be slightly different. Just be sure when you get the pulley unit that you also get the gear that goes on the tractor shaft. If your C did not have a pulley originally, there may not be a gear on that shaft and if the gear is different between the A and C, it would not work anyway. The shaft that the gear goes on is the same between the A and C. I took a pulley unit off a C and put it on my 1946 Hebard Shop mule.

Randy in NE · May 12, 2010

The part numbers for the 8 1/2" are the same so it should fit.

gene bender · May 12, 2010

Yes the splines are the same. Different ODs were available

Haas · May 12, 2010

I assumed you were talking about the gear box, etc. Not just the belt pulley. The belt pulleys are the same. There were different diameters of pulleys available, but most are 8 1/2 inches.

Rear Pulley For Farmall C

Ted Womack

Member

Haas

Well-known Member

Randy in NE

Member

gene bender

Well-known Member

Haas

Well-known Member

Similar threads