(800) 853-2651
SHOP NOW

Removing races on MD front wheel

A

Anonymous-0

Well-known Member
Pulled the hubs off my MD. All races, bearings, seals need replacing. Got the kit from CIH. Question: How do you get the races out of the hub? There's some kind of sheetmetal disk behind the race that would prefer not to destroy in the process. Looks like some kind of retainer to keep the grease in the bearing. Any comments, suggestions appreciated.
 
Clean it out well and you will see a place between the races that is notched to allow a long brass or soft iron punch to access the race from the opposite side. Punching in these slots drives the race out and the seal stuff as well.
Turn over and do the opposite side to get the outer bearing outer race out. Jim
 
There should be new seals in your kit. If not, get new ones. You will certainly bugger up the old ones when you remove them.

Gordo
 
Thanks gentlemen, for all your help. Everything came out like a charm, and the new stuff is now installed.
 
(quoted from post at 05:43:56 05/12/10) There should be new seals in your kit. If not, get new ones. You will certainly bugger up the old ones when you remove them.

Gordo
Click to expand...

The grease seal should stay on the spindle, along with the inner cone which is a press fit.
 
You must log in or register to reply here.

Similar threads

T
Front wartime spoke cutoff wheel trouble
Replies
6
Views
382
Mark-Ia
M
S
47A front hub
Replies
1
Views
208
greenmech
greenmech
B
Farmall m front wheel bearing grease retainers
Replies
11
Views
547
chhanes
C
T
Wartime front spoke wheel hub setup
Replies
0
Views
258
Tstoner
T
W
Work on the narrow front WD steering continues...
Replies
0
Views
244
Will Herring
W
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top