9 bolt steel on a Farmall M

Red Rookie · May 8, 2010

Hello,
I like the way that pressed steel wheels look and am thinking about putting some on my M. I was wondering what options I have for hubs for a 9 bolt wheel? I know I can get clamp on dual hubs for an M with a 2 3/4" axle but will larger ones- say from a 706- clamp down far enough? Are weld on hubs the way to go? Just looking for opinions and what options may be available.
Thanks!

MN Scott · May 8, 2010

A set of clamp on hubs is about the only option. 706 hubs are totally different.

rustyfarmall · May 8, 2010

(quoted from post at 08:54:17 05/08/10) Hello,
I like the way that pressed steel wheels look and am thinking about putting some on my M. I was wondering what options I have for hubs for a 9 bolt wheel? I know I can get clamp on dual hubs for an M with a 2 3/4" axle but will larger ones- say from a 706- clamp down far enough? Are weld on hubs the way to go? Just looking for opinions and what options may be available.
Thanks!

The clamp-on hubs have got to be for the 2 3/4" axle, so your choices are limited to the M, Super M, 400, 450, and possibly the 560. The hubs from a tractor with axles larger than 2 3/4" will NOT work.

I had intended to do the same thing on my M, and bought some 9 bolt rims with rotted tires and then found some clamp-on hubs. I never used any of it, probably never will.

Bernie S · May 9, 2010

Hubs from a Massey 44 will work I am told. I used M&W hubs on my M Bernie

Harold H · May 9, 2010

The only hubs I know of that will fit the M are M&W dual hubs which you should be able to find or IH hubs that were offered for 34 inch steel wheel options on the Farmall 560 and the Farmall 656, but these will probably be hard to find.

Harold H

9 bolt steel on a Farmall M

Red Rookie

New User

MN Scott

Well-known Member

rustyfarmall

Well-known Member

Bernie S

New User

Harold H

Well-known Member

Similar threads