(800) 853-2651
SHOP NOW

farmall 200 governor

L

les holman

New User
Just finished replacing the springs bearings and bushings in the governor of my old 200 when i went to put it back on the tractor the carb linkage won't move when i take it back off it works fine. What am i doing wrong ?
Thanks in advance for any suggestions
 
Might need a little clarification.

Is it the arm on the carb end of the governor that doesn't move? Where is your speed control lever ( the throttle lever at the seat set?)

Is that carb-end arm of the governor connected to the carb and not moving? There is an adjustment on that rod between the arm and the throttle lever on the carb that's pretty simple and may be your problem.
 
Chances are when you put it back on the output shaft has enough end play that it got moved side ways enough to make it stuck on one of the two eats that keep it lined up. Put it back on and if it happens again just move the out=-put lever sideways enough to allow it to move. You also mite want to check the pin that keeps that shaft in position itcould be worn and not long enough to allow the shaft to turn. Sometimes you need to drive that pin in a little farther so it can guide the end play better.
 
You must log in or register to reply here.

Similar threads

L
Farmall C263 governor problem
2
Replies
33
Views
988
used red MN
U
A
Farmall H throttle problem
Replies
5
Views
603
allenleschber
A
S
Ford 3600 gas Governor problem?
Replies
11
Views
383
65Ford2000
6
F
Governor thrust spring
Replies
2
Views
211
Frank Caldwell
F
S
8N Governor issue?
Replies
8
Views
478
ShawnPalichuk
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top