(800) 853-2651
SHOP NOW

W450 D Clutch

T

Terry Harnett

New User
My W450 D doesn't disengage when clutch peddle is down,tractor hadn't run for a few years and clutch did work fine when first got her run'n,is there any internal ajustment?Thanks Terry
 
Making sure everything is adjusted properly is good preventative maintenance, but when a clutch won't engage, or won't release, there's nothing you can adjust to change that.

Odds are the clutch disk has rusted to the flywheel from lack of use. If it's not rusted too badly, driving it around with the clutch pedal held down, and hitting the brakes will generally break it free.
 
Thanks,I will go for another drive tonight and have ordered a work shop manual,took inspection cover of and was no sign of rust,looks like long block was replaced at some stage so would think clutch was done but never no,motor runs perfect on gas and diesel,Thanks Terry
 
They can stick from just sitting. It wouldn't hurt to grease the pilot bearing, but driving with the clutch down may break it loose.

Sometimes when they break loose some of the lining comes apart and since there is no place for it to go, it gets caught between the pressure plate and clutch disc and that causes the clutch to drag. it will release, but you have to start it in gear or the dragging debris will keep the gears spinning and you can't shift into gear without lots of grinding. Dissassembly is then necessary.
 
I adjusted up all linkages and made a difference on 1st and 2nd gears but as been told there is probly lining loose in the works,will use as is to see if it frees up more.Thanks Terry
 
Hi Andy,I thingk I may have figered it out,goes into gear real easy if Tork amplifier is ingaged,all linkages are ajusted correctly.Terry
 
You must log in or register to reply here.

Similar threads

D
Hart Parr 19-36 hard to put in gear
Replies
7
Views
294
scootergmc
S
R
Super C clutch pilot bearing
Replies
7
Views
429
Roger46
R
D
another fine mess
Replies
9
Views
498
Rich'sToys
R
G
Ford 355 clutch issue
Replies
14
Views
773
Check Break
C
F
Ford 821 Clutch Problem
Replies
6
Views
425
Sean in PA
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top