drawbar mount

mike paulson · Apr 22, 2010

hey guy's, under my tractor holding my draw bar lower assemble to the rear do the bolts go right into the rear because it sure looks like i'm leaking fluid from them, how can i seal them up, they were alittle loose and i did crank em tight but i always thought they went into blind holes??

tn terry t · Apr 22, 2010

you reckon someone ran a bolt in too deep and busted the blind hole out?

tn terry t · Apr 22, 2010

coould you use silicon on the threads of the bolts to seel it off?[/url]

Anonymous-0 · Apr 22, 2010

are the holes originally blind? or do they go into the rear?

DeltaRed · Apr 22, 2010

They should be blind.Are you sure that the oil isnt leaking from the pto or tran input shaft and running doun the outside to the lowest point?

S2710 · Apr 22, 2010

The holes should be blind. Just take out one bolt at a time and if oil starts leaking out of one hole just drain the rear end and clean the hole up real good and then use a good thread sealent on the bolt and put it back in and the problem should be fixed.
Bob

mike paulson · Apr 23, 2010

i checked and the oil looks like it is coming right from the bolts, i will try pulling them to see whats up..

drawbar mount

mike paulson

Member

tn terry t

Well-known Member

tn terry t

Well-known Member

Anonymous-0

Well-known Member

DeltaRed

Well-known Member

S2710

Well-known Member

mike paulson

Member

Similar threads