(800) 853-2651
SHOP NOW

H STEERING SPINDEL BUSHINGS

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

L

LARRY LAURITZEN

New User
Have replaced bushings on front steering spindel, top and bottom on 1946 H. The bottom is fine, the top is loser now than befor. Is ther more than one top bushing for the H ? The shaft shows no wear but you can see the top move back and forth.
 
IH or Schwartz WFE? Tie rods in front or rear?
I just replaced the lower bearing and bushings on an IH WFE on a SH. Die to elongation, corrosion and other wear I had to machine fit each part. Helluva long day.

Gordo
 
I have not seen where a new bushing was looser than the old one but they are not really tight. I have an M apart right now and the shaft is worn some due to someone using chassis lube instead of gear oil and then it doe not get down to the shaft there fore wears it in time. I am going to see if it will hold gear lube with new bushing and seal before I consider getting shaft built up as that is a real pain. I have never come across any different size bushing, but with todays parts hard to tell what tolerence they are being held to.
 
You must log in or register to reply here.

Similar threads

K
farmall parts & diagrams Farmall H Steering source
Replies
2
Views
188
Janicholson
Janicholson
M
450 power steering unit
Replies
2
Views
533
Mike Fitz
M
A
Farmall H brake bushings advice
Replies
4
Views
589
allenleschber
A
B
H 9 speed again
Replies
2
Views
472
D Slater
D
V
Oliver 1800a steering box
Replies
3
Views
417
P Heisey Harleysville,PA
P
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top