(800) 853-2651
SHOP NOW

super c rear housing pulley help identify

M

markus54

New User
I just placed a picture of my Super C rerar housing with a Kosch pulley on it ..would someone please go to {help identify} and would someone be able to tell me if this housing was cut by international to make room for this drive pulley for a Kosch mid-mounted mower that i believe was ordered new by owner???
If you were to order this mower did international use this pto housing with it?..It has a 1/4" radius cut all the way accross the back and at the top of housing for it to clear...
 
I have a PTO housing with the identical groove in it, and it wasn't there before my father bought the mower. The Kosch pulley cut the groove all by itself. Either the pulley got a little loose, or something bent it, or somebody pushed it a little too far on to the shaft. If you check you can probably see that the edge of the pulley is polished , or even sharpened a little where it rubbed.

I don't know which pulley hub you have, but if you are going to use the mower very much, you should make sure that the pulley is as tight as possible. If it runs loose it will eventually, (in ten or twenty years), destroy the splines on the PTO shaft. Long before that it will wobble and make noise, as well as cutting th groove deeper into the housing.
 
I do not see a pulley being able to grind that much away....the pulley would be destroyed long before...and it would take several pulley"s to do that...i thank you for the reply and take it into consideration..if if was because of that rubbing..he must have changed it several times ...and i would think that he would have just moved it back a little on the shaft after buying the second pulley...but maybe the pulley has a hard time keeping tight ???I don"t know as i have never used one for a long time....
 
You must log in or register to reply here.

Similar threads

D
Rear mount sickle mower for Super C w/ mid mount belly mower
Replies
6
Views
484
gene bender
G
H
Cub Steering Housing Gasket Repair
Replies
4
Views
276
Hotflashjr
H
M
Super C Carb Identification
Replies
4
Views
274
mainer76
M
Slow lane 49
350 utility belt change
Replies
6
Views
459
Slow lane 49
Slow lane 49
E
Clutch release sleeve on Super C does not stay in place
Replies
15
Views
771
used red MN
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top