SM starter

scot in pa · Mar 29, 2010

The starter switch for the rod is going bad. I'd like to swap over to a solenoid starter. I think I can just swap the switch for the solenoid, or would I have to swap the starter, too?

Bob M · Mar 29, 2010

You"ll need to swap the original starter for one with a threaded terminal stud. (The starter you have now has a copper button terminal instead of a stud.)

Or you can take your original starter to a good starter shop and have them replace the button with a threaded stud. It"ll cost a lot less than a new starter!

scot in pa · Mar 31, 2010

I might go the starter shop route then. I was thinking it wasn't as simple as pulling the switch and sticking the solenoid on it. Thanks

SM starter

scot in pa

Member

Bob M

Well-known Member

scot in pa

Member

Similar threads