Anonymous-0
Well-known Member
I'm hoping that someone can tell me what I'm doing wrong... I've got a old single action IH hyd cylinder that I'd like to rebuild but I can't get it apart.
The bottom is welded, but the top looks like it should unscrew from the body. I've tried turning it but it only spins. Their is a small slit in the body up near the op where you can see what looks like a lock, and when the vent/discharge hole is lined up with the slot their is a gap. Any ideas?? I think the revision numbers are still readable...
The bottom is welded, but the top looks like it should unscrew from the body. I've tried turning it but it only spins. Their is a small slit in the body up near the op where you can see what looks like a lock, and when the vent/discharge hole is lined up with the slot their is a gap. Any ideas?? I think the revision numbers are still readable...