(800) 853-2651
SHOP NOW

Flat washer in sediment bowl.

D

Dellbertt

Member
The offset body of the sediment bowl on my 300U hits the power steering housing which makes it impossible to remove. I am going to have to raise the gas tank to get the bowl off which is not easy. I'd like to have a chat with the person that engineered that. But then again, the gas cap has always rubbed on the cowling on that tractor so maybe someone installed the gas tank to low.

Question: When I remove the glass bowl there was a flat fender washer laying in the bottom of the bowl. I have cleaned and repaired many sediment bowls and never found a washer in any of them. Anyone know the reason for a flat washer being in the glass bowl.

Thanks,
Dell
 
perhaps for the same reason I "hid" some fireplace brick in a wall before sheetrocking - it was funny at the time knowing someday someone would ask why put this here?
 
While flying F4's in the Navy, I was doing the paperwork following the mission. I wrote "the stick just doesn't feel right in the fore and aft movement".
Upon inspection of the controls area in the vertical fin (tail) they found a piece of 2x4 about two feet long.

Gordo
 
You must log in or register to reply here.

Similar threads

M
soaked sediment bowl
Replies
14
Views
1K
Mike(NEOhio)
M
L
MF 210 fuel sediment bowl replacement?
Replies
3
Views
135
Lyman1903
L
J
Jubilee sediment bowl screw
Replies
2
Views
214
Jim.ME
J
N
Gas Tank and Glass Bowl not filling
Replies
10
Views
623
NW-FLORIDA
N
A
Leak at sediment bowl
2
Replies
26
Views
921
2thmkr
2
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top