(800) 853-2651
SHOP NOW

H Carb Adjustment

M

Minnesotan H

Member
Thanks to everyone on this website my H is running pretty darn good. I have tweeked the carb fuel adjustment screw on the bottom of the carb but I'm not sure I have found the "sweet spot" just yet because I haven't adjusted it under a load. What will happen if I screw it out too far? This spring I'll be pulling a 2-14 plow so that's the time to do it. How much play to I have from "in and out" with the screw? 1/4 turn, half turn? What is the margin of error to get the right sweet spot?
 
(quoted from post at 01:07:53 02/18/10) Thanks to everyone on this website my H is running pretty darn good. I have tweeked the carb fuel adjustment screw on the bottom of the carb but I'm not sure I have found the "sweet spot" just yet because I haven't adjusted it under a load. What will happen if I screw it out too far? This spring I'll be pulling a 2-14 plow so that's the time to do it. How much play to I have from "in and out" with the screw? 1/4 turn, half turn? What is the margin of error to get the right sweet spot?
Click to expand...

Factory initial setting is three turns off the seat. Your H will pull that 2-14s just fine at that setting.
 
You must log in or register to reply here.

Similar threads

G
Super A governor adjustment
Replies
5
Views
291
560Dennis
560Dennis
4
mm uts ttx 24 carb adjustment
Replies
2
Views
164
Duey C
D
J
3010 gas carb adjustment
Replies
1
Views
264
Jim.ME
J
M
Farmall C or SC, Carter Carb
Replies
6
Views
475
old
O
T
Nut on 986 front end?
Replies
3
Views
163
caterpillar guy
C
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top