(800) 853-2651
SHOP NOW

1086 International

A

Anonymous-0

Well-known Member
I recently bought a 1086 and so far have only used it to plow snow. The govenor don"t seem to be working at all, when it starts pulling a little, like going up a hill I have to give it more gas to keep it from dying. Is there an easy way to check it out ? There is a box like cover on top of govenor, if I take this off will I be able to see anything that could be the problem ? I would appreciate any help you can give me. I really like this tractor but this is something that"s got to be fixed. It"s worrisome.
 
At what rpm are you talking about. The gov action on these models is next to nill at say below 1200 rpm. Notice how it doesn't smoke black much when it is idleing and you open the throttle, due to the walking beam type gov internal linkage. This can be mostly overcome with internal adjustments but these would best be done on a test bench or hooked to a dynamometer. It requires adjusting the droop screw and or cam nose angle. Of course, your governor may be worn out if it doesn't have good response at higher rpms.
 
You must log in or register to reply here.

Similar threads

C
IH 1086 Temp gauge
Replies
2
Views
163
Mrfred54
M
K
international 656 hydro deceleration valve question
Replies
1
Views
188
tstoub77
T
S
Chisel plow ?
Replies
6
Views
831
paul
P
M
Sickle Bar and Plow ID
Replies
16
Views
461
mainer76
M
C
international 756
Replies
9
Views
460
Mrfred54
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top