I 340 hyd. flush

Don Ober · Feb 6, 2010

Is there a good way to flush the system I had drained it and refilled but still shows milky in oil I had been haveing problem with the lift ,seems that the moisture in the system is the problem,already used up most my banked cuss words on it.THANKS Don

CNKS · Feb 6, 2010

No good way. There is water in every line and every part of the system. As part of my "restoration" of my 460, I completely disassembled the hydraulics. There was water everywhere. Only way I know is to keep buying hyd fluid-$$$-and change it until it is more or less clean. And, it may not be the water. Mine worked ok before I took it apart. Did you change the filter?

rustred · Feb 6, 2010

you need to check and see if your pressure is up to spec. if its not and the filter is good and the oil is milky, you may have an air leak at the suction line. you need to remove the pump and replace the seal at the inlet.

bc · Feb 6, 2010

Not sure I'd blame it on the oil either. The rockshaft housing up under the seat holds a couple gallons or more as well.

I 340 hyd. flush

Don Ober

Member

CNKS

Well-known Member

rustred

Well-known Member

bc

Well-known Member

Similar threads