(800) 853-2651
SHOP NOW

1066 international tractor

In park or moving? More details are needed to better asses your problem. Where is the noise coming from? At first glance I would say low oil pressure in the engine.
 
In park or moving? More details are needed to better asses your problem. Where is the noise coming from? At first glance I would say low oil pressure in the engine.Could be a simple piece of sheet metal vibrating.
 
If it is coming from injection pump it is the intravance in pump. If from transmision most likely dampener in clutch disc.
 
I agree, more details are needed on conditions when noise is prevalent. If noise is in neutral and due to clutch tuning (affected by clutch disc damper tuning & other factors), it will be affected (mitigated or eliminated) by pressing on the clutch pedal to the point where pressure is brought to bear on the clutch release fingers by the throwout bearing. If the noise does go away under these conditions, it is nothing to worry about. For any other noise (with the conditions so stated), I'm sure others will have some good insight into causal factors.
 
I have the same thing with my 686 it has a little rattle only when idling but i think its the through out bearing in front of the ta clutch. When i pull back on the ta the noise goes away. Erik..
 
You must log in or register to reply here.

Similar threads

M
  • Question
f 1066
Replies
1
Views
256
rustred
rustred
N
1066 engine overhaul
2
Replies
20
Views
1K
Janicholson
Janicholson
A
  • Discussion
International 1066
Replies
0
Views
120
Anonymous-0
A
L
Heat Exchanger Farmall 06 & 66 series
Replies
2
Views
219
Luther D
L
J
1066 front end on 856
Replies
5
Views
508
DeltaRed
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top