(800) 853-2651
SHOP NOW

301 into a 460

4

460Jason

New User
I know this has been discussed on here before, but I cannot find it.Wanting to wake up a 460 a little with a 301 gas from a 715 combine.What do I need to use for a back plate, flywheel and torque tube? Is there any machining that needs done or is this all bolt on.
thanks for any replies.
 
Use whatever is different off the C221.

About the only change you will to make is use longer bolts with nuts for the backing plate to block. Ag engines use threaded holes in the block while the combine has the bolts install the other way with the threads in the bell housing.
 
Jason - get a copy of the Sept-Oct 2009 Red Power Magazine article in the "From the Shop By the Tractor Doctor" section. There is a good article by The Tractor Doctor and Tractor Nurse, Ron & Jo Anne O"Neill, Oshkosh Wi. tel # (920)-233-1250 for a Farmall 460 gas engine swap.... C-221 to C-301 gas engines. Don"t know if the 715 IH combine engine is any different that that of an 806 301 gas; maybe someone on this forum can comment. The article has very good info and photo"s on the swap you asked about.
 
Yep, for the most part, just pull the front and rear engine covers off the C221 and put them on the C301. There may be some other accessories that need to be changed, but otherwise it's a bolt-in.
 
You must log in or register to reply here.

Similar threads

B
2606 carb doesn't fit right
2 3
Replies
42
Views
925
bc
B
N
F30 electric start conversion
Replies
8
Views
563
Oldiron29
O
J
How to replace fan belt with front crankshaft driven pump ?
Replies
9
Views
624
Caryc
C
L
Quick Question - Should I Use Lock Washers on Flywheel Bolts?
Replies
2
Views
257
LarryMaine
L
D
Difference between a 460 and 560 carb?
Replies
6
Views
472
dhermesc
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top